4:16 p.m.
Hello,
I am attempting to use Packstack with an answer file to install Openstack
on two nodes -- a controller/network node and a compute node. I installed
Packstack new today.
When I run packstack with the answer file, it gets to the step: "Preparing
Neutron API entries" and then errors out. The error reads: ERROR :
"Couldn't detect ipaddress of interface ens2f1 on node 10.57.38.123"
The controller node management IP is 10.57.38.123 (on bond0). I am trying
to use ens2f1 for the OVN tunnel. It's IP address is 10.57.37.123.
Attached are my answer file and the setup log with failure.
Any ideas on what could be wrong?
Thanks,
--
Todd Leishman
toddleish(a)gmail.com
8:34 a.m.
Hi,
What version of RDO and packstack are you using?, could you provide the
output of command "ip a"?
Best regards,
Alfredo
On Mon, Jul 8, 2019 at 11:43 PM Todd Leishman <toddleish(a)gmail.com> wrote:
Hello,
I am attempting to use Packstack with an answer file to install Openstack
on two nodes -- a controller/network node and a compute node. I installed
Packstack new today.
When I run packstack with the answer file, it gets to the step: "Preparing
Neutron API entries" and then errors out. The error reads: ERROR :
"Couldn't detect ipaddress of interface ens2f1 on node 10.57.38.123"
The controller node management IP is 10.57.38.123 (on bond0). I am trying
to use ens2f1 for the OVN tunnel. It's IP address is 10.57.37.123.
Attached are my answer file and the setup log with failure.
Any ideas on what could be wrong?
Thanks,
--
Todd Leishman
toddleish(a)gmail.com
_______________________________________________
users mailing list
users(a)lists.rdoproject.org
http://lists.rdoproject.org/mailman/listinfo/users
To unsubscribe: users-unsubscribe(a)lists.rdoproject.org
3:58 p.m.
Thank you for responding.
I installed Stein.
Packstack version says 14.0.0, but I'm not sure how to determine RDO
version.
Here's the output of ip a:
[root@shp-vmc-00-man ~]# ip a
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group
default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: eno1: <BROADCAST,MULTICAST,SLAVE,UP,LOWER_UP> mtu 1500 qdisc mq master
bond0 state UP group default qlen 1000
link/ether f4:03:43:43:c1:1c brd ff:ff:ff:ff:ff:ff
3: eno2: <BROADCAST,MULTICAST,SLAVE,UP,LOWER_UP> mtu 1500 qdisc mq master
bond0 state UP group default qlen 1000
link/ether f4:03:43:43:c1:1c brd ff:ff:ff:ff:ff:ff
4: ens2f0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq master
ovs-system state UP group default qlen 1000
link/ether 3c:fd:fe:c5:82:60 brd ff:ff:ff:ff:ff:ff
inet6 fe80::3efd:feff:fec5:8260/64 scope link
valid_lft forever preferred_lft forever
5: eno3: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN group default
qlen 1000
link/ether f4:03:43:43:c1:1e brd ff:ff:ff:ff:ff:ff
6: ens2f1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP
group default qlen 1000
link/ether 3c:fd:fe:c5:82:61 brd ff:ff:ff:ff:ff:ff
inet 10.57.37.123/24 brd 10.57.37.255 scope global ens2f1
valid_lft forever preferred_lft forever
inet6 fe80::3efd:feff:fec5:8261/64 scope link
valid_lft forever preferred_lft forever
7: eno4: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN group default
qlen 1000
link/ether f4:03:43:43:c1:1f brd ff:ff:ff:ff:ff:ff
8: bond0: <BROADCAST,MULTICAST,MASTER,UP,LOWER_UP> mtu 1500 qdisc noqueue
state UP group default qlen 1000
link/ether f4:03:43:43:c1:1c brd ff:ff:ff:ff:ff:ff
inet 10.57.38.123/24 brd 10.57.38.255 scope global bond0
valid_lft forever preferred_lft forever
inet6 fe80::f603:43ff:fe43:c11c/64 scope link
valid_lft forever preferred_lft forever
11: ovs-system: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN group
default qlen 1000
link/ether b6:0f:96:16:31:4e brd ff:ff:ff:ff:ff:ff
13: br-int: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN group
default qlen 1000
link/ether 6e:e9:0e:c6:42:48 brd ff:ff:ff:ff:ff:ff
14: genev_sys_6081: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 65000 qdisc
noqueue master ovs-system state UNKNOWN group default qlen 1000
link/ether d6:7e:75:80:f9:ce brd ff:ff:ff:ff:ff:ff
inet6 fe80::d47e:75ff:fe80:f9ce/64 scope link
valid_lft forever preferred_lft forever
17: br-ex: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state
UNKNOWN group default qlen 1000
link/ether 3c:fd:fe:c5:82:60 brd ff:ff:ff:ff:ff:ff
inet 10.57.36.217/24 brd 10.57.36.255 scope global br-ex
valid_lft forever preferred_lft forever
inet6 fe80::6ccc:80ff:fe30:b541/64 scope link
valid_lft forever preferred_lft forever
Best Regards,
Todd
On Thu, Jul 11, 2019 at 7:35 AM Alfredo Moralejo Alonso <amoralej(a)redhat.com>
wrote:
Hi,
What version of RDO and packstack are you using?, could you provide the
output of command "ip a"?
Best regards,
Alfredo
On Mon, Jul 8, 2019 at 11:43 PM Todd Leishman <toddleish(a)gmail.com> wrote:
> Hello,
> I am attempting to use Packstack with an answer file to install Openstack
> on two nodes -- a controller/network node and a compute node. I installed
> Packstack new today.
>
> When I run packstack with the answer file, it gets to the step:
> "Preparing Neutron API entries" and then errors out. The error reads:
> ERROR : "Couldn't detect ipaddress of interface ens2f1 on node
10.57.38.123"
>
> The controller node management IP is 10.57.38.123 (on bond0). I am
> trying to use ens2f1 for the OVN tunnel. It's IP address is 10.57.37.123.
>
> Attached are my answer file and the setup log with failure.
>
> Any ideas on what could be wrong?
>
> Thanks,
>
> --
>
> Todd Leishman
>
> toddleish(a)gmail.com
> _______________________________________________
> users mailing list
> users(a)lists.rdoproject.org
> http://lists.rdoproject.org/mailman/listinfo/users
>
> To unsubscribe: users-unsubscribe(a)lists.rdoproject.org
>
_______________________________________________
users mailing list
users(a)lists.rdoproject.org
http://lists.rdoproject.org/mailman/listinfo/users
To unsubscribe: users-unsubscribe(a)lists.rdoproject.org
--
Todd Leishman
toddleish(a)gmail.com
1:40 p.m.
Hello... I ran Packstack on a different server -- first as allinone, and
then tried to add a compute node and that same OVN tunnel config. This time
I got a different error, but also related to that interface:
ERROR : Error appeared during Puppet run: 10.57.38.122_network.pp
Error: Parameter source failed on Firewall[001 neutron tunnel port incoming
neutron_tunnel_10.57.38.122_ens2f1]: Munging failed for value "ens2f1" in
class source: host_to_ip failed for ens2f1, exception Failed to resolve
hostname ens2f1 (file:
/var/tmp/packstack/07134f0190f947268d531377829727bd/modules/packstack/manifests/firewall.pp,
line: 43)
On Thu, Jul 11, 2019 at 7:35 AM Alfredo Moralejo Alonso <amoralej(a)redhat.com>
wrote:
Hi,
What version of RDO and packstack are you using?, could you provide the
output of command "ip a"?
Best regards,
Alfredo
On Mon, Jul 8, 2019 at 11:43 PM Todd Leishman <toddleish(a)gmail.com> wrote:
> Hello,
> I am attempting to use Packstack with an answer file to install Openstack
> on two nodes -- a controller/network node and a compute node. I installed
> Packstack new today.
>
> When I run packstack with the answer file, it gets to the step:
> "Preparing Neutron API entries" and then errors out. The error reads:
> ERROR : "Couldn't detect ipaddress of interface ens2f1 on node
10.57.38.123"
>
> The controller node management IP is 10.57.38.123 (on bond0). I am
> trying to use ens2f1 for the OVN tunnel. It's IP address is 10.57.37.123.
>
> Attached are my answer file and the setup log with failure.
>
> Any ideas on what could be wrong?
>
> Thanks,
>
> --
>
> Todd Leishman
>
> toddleish(a)gmail.com
> _______________________________________________
> users mailing list
> users(a)lists.rdoproject.org
> http://lists.rdoproject.org/mailman/listinfo/users
>
> To unsubscribe: users-unsubscribe(a)lists.rdoproject.org
>
_______________________________________________
users mailing list
users(a)lists.rdoproject.org
http://lists.rdoproject.org/mailman/listinfo/users
To unsubscribe: users-unsubscribe(a)lists.rdoproject.org
--
Todd Leishman
toddleish(a)gmail.com
3:02 p.m.
Nevermind to that last post... I had entered the interface name into the
wrong field... I set that correctly, re-ran packstack, and this node also
gets the same error as the first node: ERROR : "Couldn't detect ipaddress
of interface ens2f1 on node 10.57.38.122"
On Thu, Jul 11, 2019 at 7:35 AM Alfredo Moralejo Alonso <amoralej(a)redhat.com>
wrote:
Hi,
What version of RDO and packstack are you using?, could you provide the
output of command "ip a"?
Best regards,
Alfredo
On Mon, Jul 8, 2019 at 11:43 PM Todd Leishman <toddleish(a)gmail.com> wrote:
> Hello,
> I am attempting to use Packstack with an answer file to install Openstack
> on two nodes -- a controller/network node and a compute node. I installed
> Packstack new today.
>
> When I run packstack with the answer file, it gets to the step:
> "Preparing Neutron API entries" and then errors out. The error reads:
> ERROR : "Couldn't detect ipaddress of interface ens2f1 on node
10.57.38.123"
>
> The controller node management IP is 10.57.38.123 (on bond0). I am
> trying to use ens2f1 for the OVN tunnel. It's IP address is 10.57.37.123.
>
> Attached are my answer file and the setup log with failure.
>
> Any ideas on what could be wrong?
>
> Thanks,
>
> --
>
> Todd Leishman
>
> toddleish(a)gmail.com
> _______________________________________________
> users mailing list
> users(a)lists.rdoproject.org
> http://lists.rdoproject.org/mailman/listinfo/users
>
> To unsubscribe: users-unsubscribe(a)lists.rdoproject.org
>
_______________________________________________
users mailing list
users(a)lists.rdoproject.org
http://lists.rdoproject.org/mailman/listinfo/users
To unsubscribe: users-unsubscribe(a)lists.rdoproject.org
--
Todd Leishman
toddleish(a)gmail.com
2089
days inactive
2093
days old
4 comments
2 participants
participants (2)
-
Alfredo Moralejo Alonso -
Todd Leishman