Re: [rdo-list] [TripleO] quickstart undercloud problems.

Sent from my mobile On Nov 19, 2016 09:53, "Nate" <war(a)undrground.org&gt; wrote: then the moment you hit send, a lightbulb goes on, and you fix your ow problem? Ha, I know I have. Not a problem, we're on #rdo if anything else comes up. Take care iptables (like I've told it to) and it was too restrictive. I flushed iptables, and disabled puppet (so it wouldnt turn it back on again) rebooted the undercloud vm, and guess what? It's on the network now. and ooo quickstart on Centos 7. https://www.rdoproject.org/tripleo/ setting $VIRTHOST to localhost, or the local IP of the box (192.168.3.10), I've tried it both ways, which doesn't seem to make a difference. I'm running quickstart as my local use, not the stack user. and whatnot, it even starts up the undercloud vm as the stack user. > > [stack@fog ~]$ virsh list > Id Name State > ---------------------------------------------------- > 2 undercloud running > When quickstart gets to the point where it's attempting to determine the IP of the undercloud VM, it fails. I did a little digging on how exactly that works, and found that the script which it runs is not getting any results. }') neigh. address/ { print $2; exit }' '{print $1;}' watch it boot, and I see the following in the boot messages: username/pass. or I'd troubleshoot that further. > As far as I can tell the undercloud system uses standard linux bridges to setup network communication, They appear present, but as they're not configured in the same manner i've used in the past, I can't be certain if they're working properly. > > [stack@fog ~]$ brctl show > bridge name bridge id STP enabled interfaces > brext 8000.525400af4796 no brext-nic > tap0 > brovc 8000.525400180812 no brovc-nic > tap1 > virbr0 8000.525400a3f6b5 yes virbr0-nic > [stack@fog ~]$ ifconfig brext-nic > brext-nic: flags=4098<BROADCAST,MULTICAST> mtu 1500 > ether 52:54:00:af:47:96 txqueuelen 500 (Ethernet) > RX packets 0 bytes 0 (0.0 B) > RX errors 0 dropped 0 overruns 0 frame 0 > TX packets 0 bytes 0 (0.0 B) > TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 > > [stack@fog ~]$ ifconfig brovc-nic > brovc-nic: flags=4098<BROADCAST,MULTICAST> mtu 1500 > ether 52:54:00:18:08:12 txqueuelen 500 (Ethernet) > RX packets 0 bytes 0 (0.0 B) > RX errors 0 dropped 0 overruns 0 frame 0 > TX packets 0 bytes 0 (0.0 B) > TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 > I've tried some other basics, like setting selinux to permissinv and re-trying (which was a long shot) and it didn't help.