Re: [Rdo-list] Glance does not save properties of images
Hello Daniel,
On your posted glance-api.con noticed default_store = rbd, assuming Glance back end is
CEPH (correct?).
Just installed AIO RDO Havana on RHEL 6.5.
Is_public updated successfully via Horizon\CLI, image shows up as public on
Horizon\image-show.
I'm assuming (the obvious..) that you checked this on more than just that one image,
eliminates a single bad image as source of this problem.
BTW what type\source of image was used\checked?
Another difference in setups mine notifier_strategy =QPID your's uses rabbit.
Regards,
Tzach
----- Original Message -----
From: "Daniel Speichert" <daniel(a)speichert.pl>
To: "Flavio Percoco" <flavio(a)redhat.com>
Cc: rdo-list(a)redhat.com
Sent: Wednesday, January 29, 2014 4:30:56 PM
Subject: [Rdo-list] Glance does not save properties of images
----- Original Message -----
From: "Flavio Percoco" <flavio(a)redhat.com>
To: "Daniel Speichert" <daniel(a)speichert.pl>
Cc: "Lars Kellogg-Stedman" <lars(a)redhat.com>, rdo-list(a)redhat.com
Sent: Tuesday, January 28, 2014 3:37:27 AM
Subject: Re: [Rdo-list] Glance does not save properties of images
Could you please share the commands your using?
- How are you adding the properties?
- How are you reading the propoerties?
You're sharing your registry.log configurations which means you've
configured the registry. Could you share how you did that?
Thanks,
flaper
These are required properties when adding any Glance image (disk_format and
container_format). I was trying to set is_public through 'glance image-edit' and
Horizon. The change seems to be accepted (no error) but on subsequent image-show it's
just not there.
Registry and API are set up almost by defaults:
glance-registry.conf: http://pastebin.com/M7Ybjnf9
glance-api.conf: http://pastebin.com/5sPXr3mG
Regards,
Daniel Speichert
_______________________________________________
Rdo-list mailing list
Rdo-list(a)redhat.com
https://www.redhat.com/mailman/listinfo/rdo-list