Re: [Rdo-list] Trying out Neutron Quickstart running into issues with netns (l2 agent and dhcp agent)

On 08/13/2013 08:09 PM, Perry Myers wrote: > On 08/04/2013 09:57 AM, Perry Myers wrote: >> Hi, >> >> I followed the instructions at: >> http://openstack.redhat.com/Neutron-Quickstart >> http://openstack.redhat.com/Running_an_instance_with_Neutron > > Ok, I wanted to close the loop on this thread with some things I found. > > It appears that the issues I was seeing had to do specifically with the > 114.openstack kernel in the RDO Grizzly repos. This kernel had issues > with being able to change MAC addresses with an interface that is in the > up state. > > A new kernel was uploaded today 114.openstack.gre.2 and rkukura sent an > announcement out about it, as it enables gre tunnel support. > > A side effect of this new kernel is that it fixed the bugs with changing > MAC addresses on interfaces that are up. > > So, with this new kernel, I'm now able to successfully get RDO Grizzly > on RHEL 6.4 with the 114.openstack.gre.2 kernel running. I can boot a > Cirros VM, get an ip address, get external connectivity from the VM and > also ssh/ping it via the floating IP. > > So... all in all, success! > > Now, the next step is doing a multi host setup. This is where the new > support for gre tunnels will be handy, since moving from 1 to many nodes > requires either VLAN support or tunnels, and since I don't have an > intelligent switch, gre tunnels it is. Oh, one thing to note... I did all of the above on hosts (VMs) where NetworkManager was removed. I should try on hosts where NM is enabled to see if I still have success...