[Rdo-list] RH OpenStack v4 Evaluation: Initial Setup: First Compute Node Doesn't Show Up in Hypervisor List

Rhys Oxenham roxenham at redhat.com
Wed Jul 2 17:27:24 UTC 2014


No worries! 

Can you paste out your /etc/qpidd.conf file from the controller? (Make sure you sanitise the output)

Cheers
Rhys


On 2 Jul 2014, at 18:23, Lodgen, Brad <Brad.Lodgen at centurylink.com> wrote:

> Thanks for the quick response! Based on the below log findings and what I just found searching, is this caused by the controller host group parameter "freeipa" being set to the default "false"? Change it to "true"?
> 
> 
> 
> On the compute node, I'm seeing this over and over in the compute log:
> 
> Unable to connect to AMQP server: Error in sasl_client_start (-1) SASL(-1): generic failure: GSSAPI Error: Unspecified GSS failure.  Minor code may provide more information (Cannot determine realm for numeric host address). Sleeping 5 seconds
> 
> On the controller conductor log:
> 
> Unable to connect to AMQP server: Error in sasl_client_start (-1) SASL(-1): generic failure: GSSAPI Error: Unspecified GSS failure.  Minor code may provide more information (Cannot determine realm for numeric host address). Sleeping 5 seconds
> 
> In the controller messages file:
> 
> python: GSSAPI Error: Unspecified GSS failure.  Minor code may provide more information (Cannot determine realm for numeric host address)
> 
> 
> 
> 
> 
> -----Original Message-----
> From: Rhys Oxenham [mailto:roxenham at redhat.com] 
> Sent: Wednesday, July 02, 2014 12:14 PM
> To: Lodgen, Brad
> Cc: rdo-list at redhat.com
> Subject: Re: [Rdo-list] RH OpenStack v4 Evaluation: Initial Setup: First Compute Node Doesn't Show Up in Hypervisor List
> 
> Hi Brad,
> 
> Have you checked the nova-compute logs in /var/log/nova/compute.log (on your new compute node?)
> 
> This should point towards why it's unable to connect/start etc. I suspect that it's unable to join the message queue, and hence show up as an available hypervisor.
> 
> Many thanks
> Rhys
> 
> On 2 Jul 2014, at 18:05, Lodgen, Brad <Brad.Lodgen at centurylink.com> wrote:
> 
>> Hi folks,
>> 
>> I have an issue where I've just done the initial setup and added a controller node, it finished, then I added a compute node, it finished, but I don't see the compute node in the hypervisor list on the dashboard. I'm using the RH OpenStack evaluation version 4. I have five hosts present in Foreman.
>> 
>> -Foreman host (purely for Foreman)
>> -Controller host (applied Controller(Nova) host group) -Compute Host 
>> (applied Compute(Nova) host group)
>> -2 other hosts (not host group applied, but one will be compute and 
>> one will be storage)
>> 
>> Did I miss something on the controller/compute host group parameters that would cause it to not show up in the dashboard?
>> _______________________________________________
>> Rdo-list mailing list
>> Rdo-list at redhat.com
>> https://www.redhat.com/mailman/listinfo/rdo-list
> 





More information about the dev mailing list