Hi Marius,
I did so, I can see libvirtd has been installed on both nodes and active but they are not appearing as support service in the command Openstack-status in both nodes.
Here is my answers file: http://pastebin.com/sLQiGhLy
Here is Openstack-Status for controller node: http://pastebin.com/8zTvcDfT
Here is Openstack-Status for compute node: http://pastebin.com/aSFw7dLF
What do you advise?
Thanks,
Ashraf
From: Marius Cornea [mailto:marius@remote-lab.net]
Sent: Tuesday, 9 February 2016 2:37 PM
To: Ashraf Hassan <asma2103@yahoo.com>
Cc: rdo-list@redhat.com
Subject: Re: [Rdo-list] Deploying Openstack with Packstack
Minimal, packstack does the installation for you. Just make sure you have the repos mentioned in the guide. Thanks.
But what the is the perquisite as RHEL/Centos Installation for Packstack to work for both Controller and Compute nodes (i.e. Minimal Install, Compute Node, Infrastructure Server, ...etc.)
Hi,
Here is the quickstart link:
https://www.rdoproject.org/install/quickstart/
You can get started with a minimal CentOS/RHEL. For deploying the 2
node deployment you can generate an answer file(packstack
--gen-answer-file) and adjust the IP addresses for
CONFIG_CONTROLLER_HOST and CONFIG_COMPUTE_HOSTS. Please note that you
need ssh key-based authentication for those 2 hosts.
Thanks,
Marius
On Mon, Feb 8, 2016 at 5:38 PM, Ashraf Hassan <asma2103@yahoo.com> wrote:
> Hi Experts,
> I want to test deploying Openstack using Packstack on 2 nodes using
> answers file:
> 1- Node will act as a controller node.
> 2- Node will act as a compute node.
> What is the level of installation is needed for RHEL/Centos (Minimum,
> Hypervisor host, or etc...)
> Can someone advise please?
> Thanks,
>
> Ashraf
>
>
>
>
> _______________________________________________
> Rdo-list mailing list
> Rdo-list@redhat.com
> https://www.redhat.com/mailman/listinfo/rdo-list
>
> To unsubscribe: rdo-list-unsubscribe@redhat.com